fra0416
plumbing04.htm Plumbing

About Lifelong Learning - Contact Us - DonateFree-Ed.Net Home   Bookmark and Share

INSTALLING THE SEATS

The last item to be installed on a water closet is the seat. The seat is connected to the water closet bowl with washers and locknuts.

Installing the seat. Use the following steps to install the seat (see Figure 34):

  1. Set seat’s bolts through bowl's holes.
  2. Slide washer over bolts, and screw locknuts on hand-tight.
  3. Line up seat on bowl, and tighten locknuts with a wrench.

FIGURE 34.  INSTALLING WATER CLOSET SEAT
FIGURE 34. INSTALLING WATER CLOSET SEAT


David L. Heiserman, Editor

Copyright   SweetHaven Publishing Services
All Rights Reserved

Revised: June 06, 2015