Essentials of
Plumbing

shpslogo.jpg (6992 bytes)

INSTALLING FAUCETS

There are many types and styles of faucets. When attaching a single or combination faucet to a lavatory or sink, follow the manufacturer's instructions. All faucets are attached to a lavatory/sink in basically the same manner. Use the following steps to install a single or combination faucet (see Figure 7):

FIGURE 7. INSTALLATIONS OF FAUCETS
FIGURE 7. INSTALLATIONS OF FAUCETS

 

  1. Apply plumber's putty to the bottom of the faucet.
  2. Set the faucet in the holes provided for the faucets.
  3. From under the lavatory/sink, slide a washer on each threaded end, and screw the locknuts on until they are hand-tight.
  4. Using a basin wrench, tighten the locknuts.
  5. Wipe off all excess plumber's putty around the base of the faucet.

NOTE:  If the combination faucet comes with a gasket, plumber's putty is not applied to the base.
Primary Content Provider: U.S. Army
Publisher: SweetHaven Publishing Services

Copyright © 2005, SweetHaven Publishing Services
All rights reserved